Step 1: Go to DesignAdd Product Master
Step 2: Fill in required product details (EAN cannot be added until a later step)

Step 3: Click Save

Step 4: Go to DesignProduct List. Click on the "In Development" tab

Step 5: Enter the Product Code and click Search

Step 6: If all required details have been provided, a check box will appear. Click the checkbox and click "Confirm"

If all required details are not complete, the check box will not be available. The requirement will be listed in the "Percentage Complete" column. Click to continue editing the product.

If you wish to delete a Product "In Development", click

Adding the EAN

Step 1: Go to All tab

Step 2: Enter the Product Code you wish to add the EAN to and click Search

Step 3: Click the button highlighted below to access the view page

Step 4: Click the EAN tab and then

Step 5: Enter the EAN and click

Step 6: Click Save.

Step 7: If successful, a success message will appear.
Note: It is not possible to have two SKU's with the same EAN within the system. If you enter a duplicate EAN and save, the success message will show, but the EAN will not have been updated.